5.1. Light Output

5.1.2.1 Temporary Dimming:

Upon node selection

1. Toggle the relay on for the whole zone or off for selected nodes only.

2. Press the + or - button or use the sliding bar to adjust the light output percentage.

3. Press the Query button to read the current light output value.

5.1.2.2 Temporary Color Temperature:

Upon node selection

1. Toggle relay on for whole zone or off for selected node only

2. Press Warmer or Cooler button or use sliding bar to set a desired color temperature (from warmer to cooler)

3. Press Query button to read the current CT

5.1.2.3 Auto Operation (Light/Colour Temp):

Setting default light output (max, min & low) or default color temperature has common steps with very minor variation i.e.

Upon node selection

1. Toggle relay on for whole zone or off for selected node only

2. Choose a desired light output level by following Temporary Dimming (e.g. using sliding bar) or choose a colour temperature by following Temporary Color Temperature steps above.

3. Now click on the relevant option (“Set Max”/”Set Default CT”) to set it as the new default.

Step 3 of “set max” changes max light and when replaced with “Set Low“ or “Set Min“ configures Lowlight & Minlight.