/
3.4.3. One-To-One Paired Mode

3.4.3. One-To-One Paired Mode

By Tharushi Arachchige
2 min

This mode allows the pairing of EnOcean switches to Response nodes similar to “SWITCH ID PAIRED” mode, however, the messages generated for Response nodes are exclusive for any or all nodes paired to this switch. This means operationally the BLE messages when reach the paired nodes will not be relayed over IR for adjoining nodes in its zone. The configuration steps for EnOcean and Response nodes are done similar to as explained in SWITCH ID PAIRED mode with one extra step.

  • In Response IR App before step 4 in section 3.4.2 where you press “configure” you must toggle “One to One Pair” option before you send configuration to an EnOcean switch.

  • Similarly, before step 4 in the Response App from section 3.4.2 check the “One to One Pair” option.

All the remaining steps stay the same and get’s repeated for all Response nodes to be paired to a particular switch.

It is important to note here that you don’t need one switch to be paired individually for all nodes in the same zone. Toggle this option off if switches are meant to implement the same control for all the nodes in the same zone. The recommended use case is to provided individual control for unique luminaires out of the whole zone to behave differently from whole zone based upon commands from the paired switch only.